![]() ![]() The delay start function runs the machine’s activities at a set time, meaning that you can add items before the washing cycle kicks off. If your dishwasher has a delay start function, and an unlatched door, the cycle indicator will flash until you latch the door. Press the cancel or resume button as per your model until the sleep mode light goes off. If the child lock safety function is not the culprit, check if the machine’s sleep mode is on. ![]() This process will release the door lock and stop the blinking light. To disengage the child lock mechanism, press the child lock or power button for a few seconds or as per your owner’s manual. Some models will automatically disengage all other functions until the child lock button is reset. The machine could also be in sleep mode or child lock mode. If these processes fail, then one other culprit could be an unlatched door or a missing plug. If your machine is hard wired to your electrical system, turn off your breaker on the electrical panel. If you have reset the machine and it still will not start, then disconnect your dishwasher from its power supply for a minute. Your dishwashing machine should roar to life.īut what if the reset function fails? What do you do then? If you keep pressing different buttons, you are giving your control board varying commands, which it has to process.įor an easy reset process, press no more buttons until all lights have gone off. Therefore, you need to give the dishwasher time to process the command and halt the flashing lights. First, the reset function will not work when the lights are blinking. Unfortunately, when you are miffed by the issue, you might forget that the simplest solution to an easy reset process is patience. The confirmation that the reset function is now working is often a beep sound. The reset function will work after you have held down the start button for two to three seconds. The lights will blink for perhaps half a minute to one and a half minutes depending on the model, then stop, allowing you to reset your equipment. If your dishwasher’s cycle cannot start, the culprit could be that you have hit the button one too many times. Here’s a process you can follow to troubleshoot and fix the problem that’s causing your machine’s Start light to blink: 1. The buttons may have been pressed too many times.Unlatched door when the machine is set for delay start.Here are some of the issues that could cause the Start light to blink: There is probably an underlying problem that’s calling for your attention. A flashing dishwasher Start light is not a normal occurrence. ![]()
0 Comments
Leave a Reply. |